Materials: You will need a long sheet of paper, 60cm x15cm, two pieces of grey board and two pieces of bookcloth. These should be on your desk.
Video: Fold a 6-page zig-zag from the long sheet
Use the board chopper to cut the two pieces of grey board to the right size. Please use hand sanitiser before touching the board chopper handle and after you have finished.
Watch the video first then go to the board chopper. Helen will be on hand to help you if you need it.
Video : How to use the Board Chopper
Making the covers: each cover is made in the same way.
You will need a few pieces of scrap magazine paper to glue up on. Try not to get glue on your cutting mat or on the worktop. You will also need: ruler, corner cutter, knife, bonefolder, 2 board covers and 2 pieces of covering material, PVA glue and glue brush
Take the lid off the glue pot and stir the brush into the glue. When you are ready to glue the first board, drag the brush over the edge of the glue pot to remove glue, until you can lift the brush up without it dripping. You can use the brush like a stipple brush to get a thin even covering of glue on the board. See video:
Video: Covering a board part 2
You will need : PVA glue, brush, scrap paper for glueing
You will need two pressing boards and two pieces of non-stick paper.
Tidy up your workspace before you start the next project. Put any scraps in the bin and stand your brush in the glue pot with the lid on.
