Making the dice is about learning Fusion 360 and using as many different techniques as possible

My original method is as follows:

Sketch 10×10 square > Extrude up 10mm > draw on dots by either using the pattern tool and deleting the extras or using the construction line at a diagonal and making equal circles on that line > extruding all circles on each sketch individually by -0.5mm > filleting edges to 1mm radius

Steps which I found difficult – creating 10x10mm square at start > I would type in 10mm and then click enter as i’m used to rhino and need to do that to define the next dimension rather than tab

made a few mistakes by not clicking on commands or getting mixed up by still being in a command and trying to get into a new command

long winded process of creating a different set of circles for each face could be improved > possibly by using a pattern then copying it to each face

Storage location for all recordings : Autodesk Screencast

Strengths:

Professional looking free software which has similar capabilities as Solidworks

Can change some settings to be the same as solidworks

Weaknesses:

Another software to learn with different shortcuts

Opportunities:

Being able to use another CAD software  > Increases Employability

Threats: