Guide to setting up the PID Eurotherm controller to create composite curing cycles

This video shows how to set up the PID controller to carry out a curing cycle using the eurotherm controller. In this particular example we are looking at the standard 120°C curing cycle over 9 hours. Firstly we set the ramping time units (in most cases we use minutes), then we set the dwell time units (in most cases we use hours) . Each segment of the program starts with setting the time to ramp, then the set temperature. Then the dwelltime is defined. Then segment two will start.

Print Friendly, PDF & Email

Derek Covill

Leave a Reply

Your email address will not be published. Required fields are marked *