Etching Induction

In the print workshop I was inducted into the process of etching. We began by creating a hard ground etching onto a zinc plate. The process for doing this is as follows: file the edges of the plate at a 45 degree angle, polish the plate, rub the plate with degreaser, rinse the plate, dry the plate with a hairdryer set to cool, heat the plate and apply the hard ground with a roller, leave the plate too cool, scratch in your design, place in the acid bath for 1o minutes, rinse the plate and finally print. After experimenting with a hard ground we created another plate using soft ground, this uses the same process however the soft ground never sets, so instead of scratching the design into the surface a design can be traced on or an object can be pressed on.

Brighton Beach Rust Photography

For my hard ground design I scratched the photograph above freehand onto the plate. I chose this image as I believed the linear qualities of the texture would work well as an etching. Furthermore the imagery I chose was from my art of the accident project therefore my prints could be used as part of my materials and processes experimentation. I then played with printing the plate in black and orange inks, orange to represent the rust colour. I also experimented with printing onto newsprint, for my project I have been experimenting with the idea of creating a book printed onto transparent materials, as I couldn’t print a plate onto tracing paper or acetate I choose newsprint instead. This was a challenge as the paper was to fragile to be soaked in the water bath so had to be sprayed with a water bottle instead, however the print did turn out successful.

Below are my hard ground etching prints:

Hard Ground Black Ink Etching

Hard Ground Black Ink Second Print Etching

Hard Ground Orange Ink Etching

Hard Ground Orange Ink Etching onto Newsprint

Hard Ground Black Ink Line Work with Orange Overprint Etching

For my soft ground design I traced the photograph above onto the plate. I then used my fingers to create tonal areas.

Below are my soft ground etching prints:

Soft Ground Black Ink Etching

Soft Ground Black Ink Etching with a Hard Ground Orange Ink Etching

Soft Ground Black Ink Second Print Etching with a Hard Ground Orange Ink Second Print Etching

In my opinion my these prints were highly successful, especially the prints where I have overprinted black and orange ink, and hard and soft ground plates. Therefore I hope to find a way to incorporate them into my final book.